Valuable recommendations on how to wash faux fur in a machine and by hand

Almost every person has faux fur items in their wardrobe. However, not everyone knows how to properly care for them.

Can they be washed in a machine or in a basin? What detergent should I use to remove stains? Will synthetic bristles deteriorate after contact with water?

How to properly wash faux fur at home? Answers to these and other questions can be obtained if you read the article to the end.

Is it possible?

If the faux fur gets dirty, you can wash it. Most products tolerate such treatment well and do not lose their attractiveness.

Conditions to be followed:

1. Study the information indicated on the label. The manufacturer's recommendations should not be violated.
2. If the fur comes off, it is better to remove it and wash it separately from the main product.
3. Before you start washing, the item must be cleaned of dust and other contaminants. To do this, use a low-power vacuum cleaner or a soft-bristled brush.
4. Washing fur items together with other items is unacceptable.
5. If there are minor stains on the fur, do not wash it completely. Limited to local treatment of stains.
6. Preference is given to hand washing.

It is not recommended to machine wash long faux fur, but the shorter it is, the lower the risk of damage. You should not experiment with fur trim of questionable quality.

Then the pile is combed. This will give it freshness after a long stay in the closet.

Washing in an automatic washing machine

Before machine washing, the product must be turned inside out.. When the fibers are inside, they will not roll or tangle.

If this is not possible, then use a special mesh in which the item is placed before loading it into the drum.

Products with stubborn stains require pre-soaking. The time it is kept in the soap solution should not exceed 15 minutes.

Procedure:

1. Clean the fur from dust and place it in the drum of the washing machine.
2. Turn on delicate wash mode. You can wash fur on the “wool” and “silk” programs.
3. Synthetic pile does not tolerate contact with hot water. Its temperature should not exceed 30 degrees.
4. Disable spin. The basis of faux fur is knitwear, which does not tolerate twisting.
5. Wait for the cycle to complete.

It is better to use gels or liquid concentrates as a detergent. They rinse well and effectively remove dirt even in cool water.

Having taken the product out of the machine, you need to remove the water from it with your hands.. Not twisting, but gently running your palms over the fur.

While the water continues to drain, it is left suspended over the bathtub or over the basin. After it stops dripping, the item is removed to a dry, well-ventilated room to dry.

This video will show you how to wash faux fur in a washing machine:

How to process manually?

Items with long synthetic pile are recommended to be washed by hand.

The procedure is as follows:

1. Clean the fur from dust.
2. Fill a basin with cool water and dilute the detergent in it until completely dissolved.
3. Soak the fur for 30 minutes. If there is contamination, rub it gently with a brush. The movements should be directed from the lining along the direction of the pile, as if combing it.
4. Change the water and rinse the product.
5. Fill the basin with water again and add fabric softener. It would be good if it contained an antistatic agent.

   These can be products such as: Lenore for children, Synergetic, Ligva Soft, etc. Their average cost is 150-200 rubles per 1 liter.

6. Rinse the fur in the prepared solution. This procedure will give it softness and shine, and will get rid of static electricity.

After washing, the product is not wrung out or twisted. The water should drain from it on its own.

If light fur has acquired a yellow or grayish tint, it is recommended to treat it with hydrogen peroxide. Perform the procedure as follows:

• dissolve 1 tbsp in 1 liter of water. l. peroxides;
• pour the solution into a spray bottle;
• lay the fur on a flat surface and spray it completely;
• After 10 minutes, the product is washed in the usual way.

Dry cleaning at home

If you can’t get the product wet, you can clean it dry. Proven home remedies come to the rescue:

• starch;
• talc;
• semolina;
• soda.

They are used according to the same scheme:

1. Spread a clean cloth on the floor or table and place the fur item on it.
2. Apply the selected product to the contaminated area.
3. Gently distribute it between the pile and knead the fur with your hands.
4. Shake the item to remove any remaining powder. You can use a brush, comb or vacuum cleaner with low power.

To get maximum results, the procedure must be repeated several times until the starch or talc becomes completely clean.

To improve cleaning efficiency cereal or starch can be heated in a dry frying pan or in the microwave.

To clean dark fur, use rye bran or sawdust. Powdered activated carbon removes foreign odors well.

Drying rules

After washing, the fur product must be properly dried so that it does not lose its characteristics:

1. Shake the product to remove any remaining water.
2. Do not twist or squeeze the item. You can wrap it in a terry towel so that the water is absorbed faster.
3. Do not place the product on a radiator or hang it in the sun. Because of this, the fur is deformed.
4. During drying, the pile should lie flat, without creases, with the fluffy side up. You can hang the item on hangers without using clothespins.
5. You cannot dry your fur with a hairdryer.

Optimal conditions are drying in the fresh air, but in the shade, or in a warm room with good ventilation and low humidity.

Thanks to this simple manipulation, the villi will not bristle when they dry.

Useful tips

Information that a person should havewho decided to wash a faux fur item:

1. If it is possible to refuse washing, then it should be used. Excessive contact of the product with water will deteriorate its appearance.
2. To make the pile smooth, use fabric conditioner.
3. When the fur is dry, it needs to be combed. The comb is used with a wide distance between the teeth. You can also use a massage brush. There is no need to push the comb too far into the pile so as not to catch the fabric base.
4. If you need to wash a hood or collar with fur, it is better to unfasten it from the main product.
5. White fluff is handled with care. Stain removers are not used to eliminate yellowness and grayness.
6. The matted pile is sprayed with warm water, allowed to dry, and then combed. You can carefully walk the steamer over the product without pressing the device too tightly against the fabric.

Before using any chemicals that have not previously been used on fur, a test is carried out.

Conclusion

Faux fur items are quite easy to keep clean. To remove dirt, they resort to both machine and hand washing.

Important conditions are: use of gentle detergents, avoid spinning and processing at low temperatures.. You can tidy up your fur product at home without going to the dry cleaner.