Tips and do's and don'ts on how and what you can use to smooth out eco-leather on a jacket

Eco-leather is a modern synthetic material often used for sewing jackets.

If stored incorrectly or during wear, the item may become wrinkled.

Then a logical question arises: how to smooth the eco-leather on a jacket without damaging it? Find out how to iron artificial leather in the article.

How to iron?

At its core, eco-leather is This is a polyurethane based material, which received its name for compliance with all requirements for the protection of the environment and animals. An eco-leather product resembles natural leather, but its care and approach to smoothing are different.

You can first test the effect of the iron on an inconspicuous area of ​​the material from the inside out, and only through cotton fabric.

1. The exposure temperature should not exceed 30-40°C.
2. The steam function should be turned off.
3. The iron can only be used on the reverse side of the product.
4. Additionally, it is advisable to use a piece of chintz fabric folded in half, through which to iron from the inside out.

   If the jacket does not have a lining, then using chintz for ironing is a must.

After the jacket is ironed, it must be turned right side out and straightened out well.

Giving the item the desired shape must be done immediately, before the eco-leather has cooled down.While the sleeves have not cooled down, you can put rolls of tightly rolled towels into them to maintain their shape.

He will tell you how to iron jackets made from other materials. this chapter.

Steam ironing

Smoothing eco-leather with an iron is not always a safe activity and does not always give good results. An alternative is to use steam.

For this you can use:

• steam generator;
• steamer;
• iron with steam function, allowing vertical processing.

It is convenient to steam when the item is put on a mannequin. If you don’t have one, you can use a trempel and put rolls of towels into the sleeves. The distance from which steam can be applied is about 15-20 cm.

Very wrinkled areas can be treated for up to 10 seconds. If you need to repeat the effect, you need to wait until the eco-leather cools down.

Traditional methods for use at home

There are various ways to smooth out wrinkled areas on an eco-leather jacket. This can be done by the structural feature of the material, which is susceptible to heat. But at the same time Do not allow excessive heating of the material.

Warm water helps

The simplest and most affordable option for smoothing eco-leather is using warm water.

The jacket is moistened from the outside of the product. You can do this in the following ways:

1. By spraying heated water from a spray bottle.
2. Apply with a sponge or cloth moistened with water.

After the surface of the eco-leather has been well moistened, the item is hung to dry on hangers. Immediately you need to straighten out all the jammed areas with your hands.

Steam bath

A steam bath for straightening a wrinkled eco-leather jacket can be organized in the bathroom. To do this, you need to take the following steps:

1. Fill a bathtub or basin with hot water.
2. Hang the jacket over the bathtub so that the material does not come into contact with water.
3. Close the door to the bathroom, allowing the steam to rise up and act on the eco-leather.
4. After 60 minutes, remove the jacket from the bathroom and let it dry completely.

Hairdryer

Eco-leather is sensitive to temperature effects. This allows you to use a household appliance such as a hair dryer to smooth it out.

To do this you need:

1. Place the jacket on a horizontal surface.
2. Set the hair dryer to maximum power.
3. Direct a stream of hot air onto the dented area.

With this effect, eco-leather expands as a result of heating. If the defect cannot be corrected the first time, the process is repeated..

Vinegar

Among the folk methods of straightening eco-leather is the method of exposure to a specially prepared solution from available ingredients.

To compile it you will need:

• vinegar 3% concentration;
• fabric conditioner;
• water.

All components are mixed in equal proportions and poured into a container with a spray bottle.

Glycerin for removing creases

The use of pharmaceutical glycerin is aimed at softening eco-leather, giving it greater plasticity. Glycerin is applied to the jacket using a sponge or napkin. You can soak the sponge in glycerin directly from the bottle.

When applying it to a jacket, it is important to ensure that there are no drips and to pay attention to wrinkles that need to be smoothed out.

5 important recommendations

Putting simple recommendations into practice will allow you to smooth out the eco-leather on your jacket effectively and without unpleasant consequences.
These tips include:

1. Before you start ironing the jacket, you need to study the label on the product. It indicates how to care for the item, as well as the composition of the material.
2. If there is any doubt about what temperature can be applied to eco-leather, it is better to start with a lower temperature, gradually increasing, but not more than 40? C.
3. Smoothing must be done gradually, section by section.
4. You cannot iron eco-leather through gauze or fabric with a large textured weave of threads, as the structure can be imprinted on the eco-leather itself.
5. Until the jacket has cooled down after treatment, you should not put it on. You must wait at least half an hour.

Conclusion

You can smooth out eco-leather on a jacket in various ways, acting very carefully and monitoring the condition of the material. After the item has been ironed, it must be stored properly, preferably on a trempel in a free state.