Effective ways to remove chewing gum from leather products

foto21850-1Stuck chewing gum can ruin an expensive leather sofa, car seat, jacket, skirt, gloves and other items.

There are some tricks that allow you to carefully remove chewing gum without damaging the material.

We will tell you how to remove chewing gum from leather products in this article.

How and with what to remove chewing gum?

If you need to remove chewing gum from natural leather, there is no point in purchasing expensive products. To clean leather material from chewing gum, it is enough to use simple home methods.

Cold

Chewing gum is an elastic and soft mass that quickly sticks to hard surfaces, as well as to fabrics and skin. However, freezing the gum can make cleaning the product much easier.

If you need to clean a small item, such as a clutch or glove, you should:

  1. foto21850-2Wrap the item in a plastic bag and put it like that in the freezer.
  2. After an hour, remove the product.
  3. Then you need to take an unnecessary plastic card or metal spoon and carefully wipe the chewing gum from the material.
  4. To completely remove the stain, you should take saddle soap, rub it on a damp cloth and wipe the stained area of ​​the product with it. Saddle soap contains ingredients that effectively remove greasy marks left by chewing gum.

To remove chewing gum from the surface of a large leather item, such as a raincoat, chair, or sofa, you will need several pieces of ice.

They need to be wrapped in plastic, and then start rubbing the gum with ice.It will gradually harden, allowing you to carefully remove it with a plastic card or butter knife.

The stain, as in the first method, is removed with saddle soap.. At the end of the procedure, you need to carefully rinse off the remaining product with water and rub the skin with a special conditioner.



Do not use too sharp objects, such as kitchen knives, to remove chewing gum, as they may damage the material.

Warmth

foto21850-3High temperature helps to significantly soften the rubber mass and safely separate it from the surface of the leather item.

At home you should use dry heat, the source of which will be a hair dryer.

The device must be turned on at full power and a warm stream must be directed towards the chewing gum. The heat will effectively soften the gum, which can then be removed with a plastic spatula.

Residues can be removed with a dry soft cloth, performing circular movements. The procedure must be completed by applying a special product to remove fat from the skin. To return the product to its original appearance, you can wipe the material with a special polish.

How to wipe with soap suds?

You can use saddle soap to effectively remove chewing gum marks. This is a special product that is used to care for leather products.

First you need to lightly moisten the contaminated area with water. Afterwards, rub it gently in a circular motion with a bar of soap.

Loose gum should be removed with a soft toothbrush. Afterwards the soap should be washed off with water. Finish the procedure by applying skin conditioner.

Scotch tape

foto21850-4Scotch tape will help separate the chewing gum from the skin without harming the material.

How to use:

  1. Cut a small piece of duct tape and stick it onto the gum.
  2. Take the end of the fragment and tear it off with a sharp movement. Repeat the procedure several times until the chewing gum is completely removed.
  3. Apply conditioner.

What not to do and why?

Despite its strength and wear resistance, leather is a material that can be hopelessly damaged when exposed to strong chemicals and abrasives.

What not to use to remove chewing gum:

  • chlorine-containing products;
  • abrasive powders;
  • acetone based solvents.
The products listed above are especially harmful for colored leather, as they spoil the paint with which the material is painted.

Valuable recommendations

If the owner of a leather item is going to remove chewing gum from it himself, he The following rules must be taken into account:

  1. When using ice to remove chewing gum, you need to prevent melt water from getting on the material.
  2. Using a piece of dry cloth at the final stage of removal, you need to choose a material without lint.
  3. foto21850-5Any cleaning of products made from the skin of exotic animals (snake, crocodile) should be trusted to specialists.
  4. Before using the conditioner, you need to make sure that the chosen product does not have a tinting effect.
  5. It is not advisable to use any natural oils as they can leave greasy stains on leather upholstery.
  6. If after cleaning a stain appears, the shade of which is 1-2 shades lighter than the shade of the material, you can use nitro paint. The product must be sprayed strictly on the clarified area.
  7. Chewing gum should be removed immediately after it has stuck to the material. This will increase the chances of quick and effective skin cleansing.

You will find all the most important and useful information about removing chewing gum from various surfaces in this section.

Conclusion

The above methods will help you quickly and easily get rid of chewing gum stuck to leather or furniture.

Discussions

How to remove odor

Scratches

Yellow spots